Virex & Phoenix

General Software Questions

• Preparations for using the software Phoenix GT
• Connecting software and controller of a Virex Pro or Phoenix

Error message IT02

• IT02 Error Message

Software Settings

• Calibrate D(Base) after installation of new filters and during start-up
• V(Sys) for DIT settings
• DIT settings for PC-Client SW versions up to 3.09r2 (old software versions only!)
• DIT does not occur each day

Setting Up the CAN BUS

• How to setup connection to a Virex Pro or Phoenix over CAN BUS
• How to remove a PEAK Driver under Windows
• 4-20 mA signals input via Easy Connect (CANBus) problems
• Connecting to single units through USB after installation of Easy-Connect-Kit
• Configuring C2C modem on CAN bus with CAN-USB-Dongle
• Connecting units via CAN bus

See all 7 articles

Announcements

• New SW 3.19r1 and FW 3.25r3 released
• New Software 3.19r2 with Firmware 3.25r4 released
• New PC Software (3.22) and Firmware (3.29r1)

Tips & Tricks

• Set up a pressure transducer as level-sensor for a feed-tank
• Phoenix membrane repair kit instructions
• Virex Pro electrical specifications, power consumption
• Display of valve settings in Software
• Current output of 4-20 mA signal (max. resistor in actuator)
• Wrong datalogger configuration results in missing entries

See all 7 articles

Software Downloads

• Seccua Virex Pro and Phoenix Software 3.22r1 German
• Seccua Virex Pro and Phoenix Software 3.22r1 English
• Firmware 3.30r0 (for use with software 3.22r1, all languages)
• Which firmware fits which PC Software
• Windows - 64 Bit compatibility
• Firmware 3.29r1 (for use with software 3.22r0, all languages)

See all 8 articles